Toro Multi Pro WM 41240 Operator's Manual page 26

Application-rate Switch
The application-rate switch is located on the left side of the
control panel (Figure 30). Press and hold the switch upward
to increase the spray system application rate, or press and
hold it downward to decrease application rate.
Rate-lockout-key Switch
The rate-lockout-key switch is located on the lower, left
corner of the control panel (Figure 30). Turn the key
counterclockwise to the locked position to disable the
application rate switch, thereby keeping anyone from
accidentally changing the application rate. Turn the key
clockwise to the unlocked position to enable the application
rate switch.
Boom-lift Switches
The electric boom-lift switches raise and lower their respective
booms (Figure 30). There is a left and right lift switch. Press
and hold the switch upward to raise the respective boom, or
press and hold the switch downward to lower the respective
boom.
Sonic-boom and Foam-marker Switch
Locations (Optional)
If you install the sonic-boom and/or the foam-marker kit,
you will add switches to the control panel for controlling their
operation. The sprayer comes with plastic plugs in these
locations.
Regulating (Rate Control) Valve
This valve, located behind the tank (Figure 31), controls the
amount of fluid that is routed to the booms by directing fluid
flow to the boom.
1
2
G022362
Figure 31
1. Agitation valve
2. Regulating (rate control)
valve
3. Master-boom valve
3
4
5
4. Flowmeter
5. Boom valves
Flowmeter
The flowmeter measures the flow rate of the fluid (Figure 31).
Boom Valves
These valves turn the three booms on or off (Figure 31).
Boom-bypass Valves
The boom-bypass valves redirect the fluid flow from a boom
to the tank when you turn off the boom section. You can
adjust these valves to ensure that the boom pressure remains
constant no matter how many booms are on. Refer to
Calibrating the Boom Bypass (page 34).
Agitation-throttle Valve
This valve is located on the rear left side of the tank (Figure
32). Turn the knob on the valve to the 6 o'clock position
to turn on the tank agitation and to the 8 o'clock position
to turn off the tank agitation.
1
1. Agitation-control valve
Note: For agitation to work, the PTO and clutch must be
engaged, and the engine must be running above an idle. If
you stop the sprayer and need agitation on, place the range
shift lever in the Neutral position, let out the clutch, set the
parking brake, and set the hand throttle (if equipped).
Tank-drain Handle
The tank-drain handle is located on the left side of the
machine (Figure 33). To open the tank drain, turn the handle
to the 3 o'clock position. To close the drain, turn the handle
to the 12 o'clock position.
26
G022363
Figure 32