Setup Using Auto Pc; Selecting An Input Signal - Canon WX450ST User Manual

Setting Display Status (Input Settings)

Setup Using Auto PC

> [Input settings] >
HDMI
Digital PC
Automatically adjusts display
position misalignment and screen
flickering. The adjusted result is
stored in the memory.
Press the OK button to accept your
setting.
If the Auto PC adjustment is
insufficient, perform the following
operations.
• Select the input signal that matches
the resolution of the computer from
[Input signal select]. (P88)
• If adjustment is insufficient even
when using the above operation,
adjust [Total dots], [Tracking],
[Horizontal/Vertical position] and
[Horizontal/Vertical pixels] in [Input
signal settings].
• For the signal types supported by
the projector, see the table on
292.
Downloaded From projector-manual.com Canon Manuals
[Auto PC]
Component LAN
Analog PC USB
(P89 - P91)
page
Selecting an Input
Signal
> [Input settings] >
select]
HDMI
Digital PC
You can select a suitable resolution
if the auto PC adjustment function
(P57) cannot project the correct
image from a computer.
Press the OK button to accept your
setting and then press the MENU
button or EXIT button.
Select an input signal corresponding to
the resolution of the computer.
• For the signal types supported by the
projector, see the table on
88
[Input signal
Component LAN
Analog PC USB
page 292.