I-04] Setting The Ip Address - Canon LBP7210Cdn Manual

[I-04] Setting the IP Address

There are the following three methods for setting the IP address.
Setting the IP Address Using NetSpot Device Installer
Set the IP address using NetSpot Device Installer in the supplied CD-ROM.
Setting the IP Address Using the ARP/PING Command
If you are using an operating system equipped with Windows Firewall, set the IP address using the
ARP/PING command.
Setting the IP Address Using the Printer Status Window
If the printer driver is installed and the printer and computer are connected by a USB cable, set the IP
address using the Printer Status Window.
If you changed the IP address of the printer after installing the printer driver, reset the port to be used for the printer
driver.
After Changing the IP Address (Changing the Port)
Setting the IP Address Using NetSpot Device Installer
IMPORTANT
If Windows Firewall is enabled
It is recommended that you set the IP address using the ARP/PING command.
If you want to set the IP address using NetSpot Device Installer, you need to add
"NetSpot Device Installer" to Windows Firewall in advance. Perform either of the
following procedures.
• Adding "NetSpot Device Installer" to the [Exceptions] sheet in the [Windows
Firewall] dialog box
Readme of NetSpot Device Installer
To display Readme of NetSpot Device Installer, click [
Device Installer for TCP/IP] in the [Additional Software Programs] screen in
CD-ROM Setup.
• Installing NetSpot Device Installer (You can add it to Windows Firewall during
the installation.)
"NetSpot Device Installer"
NOTE
About the screenshots of NetSpot Device Installer
The screenshots may be different from those actually you see on the screen.
How to install NetSpot Device Installer
This section describes the procedure for using NetSpot Device Installer without installing it.
For details on the procedures for installing NetSpot Device Installer, see
Installer".
] in [NetSpot
"NetSpot Device