I-02] Auto Setup (Recommended Method) - Canon LBP7210Cdn Manual

[I-02] Auto Setup (Recommended Method)

This section describes the procedure for installing the printer driver from the supplied CD-ROM (CD-ROM Setup) on a
computer connected to the printer with a LAN cable.
Step 1: Connecting a LAN Cable
Step 2: Installing the Printer Driver from CD-ROM
Step 3: After the Installation
IMPORTANT
If your hard disk does not have sufficient space to install the printer driver
A message indicating that your hard disk does not have sufficient space appears during
installation.
Cancel the installation, free up space on your hard disk, and then reinstall the software.
Step 1: Connecting a LAN Cable
NOTE
About the network environment
This printer supports 10BASE-T and 100BASE-TX connections.
About the LAN cable
This printer does not come with a LAN cable or a hub. Have cables or a hub ready
as needed.
Use a Category 5 twisted pair cable for the LAN.
If you want to connect the printer to a 100BASE-TX Ethernet network, all the
devices to be connected to the LAN (hub, LAN cable, and network board for
computer) must support 100BASE-TX.
Contact your local authorized Canon dealer for more details.
Attach the ferrite core to the LAN cable as shown in the figure.