Canon image CLASS, LBP720 Series Manual

Checking the Items Included

Removing the Packing Material

1. Install the machine in the location where it will be used.
   
2. Remove all the packing material.
   

Loading Paper

Installing the Optional Product

If you are not using optional product, proceed to step "Connecting the Power Cord".

Before Installing the Optional Product

When installing the optional product after the machine has been installed, perform the following before starting work:

1. Shut down the machine and your computer.
2. Unplug the machine from the mains power outlet.
3. Disconnect all cords and cables from the machine.

Paper Feeder/Cassette Pedestal

When Using the Cassette Pedestal

1. Install the cassette pedestal in the location where it will be used.
   
   

• You can stack up to two paper feeders and the cassette pedestal with the machine.
  

Connecting the Power Cord

Specifying the Basic Settings

When you turn on the machine for the first time, the Setup Guide starts up on the operation panel. Perform the initial machine setup by following the on-screen instructions.

1. Select the language.
2. Select the country/region.
3. Select the time zone.
4. Set the current date/time.

Specifying the Security Settings

Set an Administrator password to increase machine security.

1. Check the message and press .
2. Select <Yes>.
   To continue without setting a password, select <No> and proceed to "Specifying the Network Settings".
3. Enter a password and select <Apply>.
   Enter the same password again and select <Apply>.
4. Check the message and press .

Specifying the Network Settings

Specify the settings for connecting the machine to a network. Before proceeding, check that the computer and router are correctly connected to the network.

Wired LAN

1. Select <Wired LAN>.
2. Connect the LAN cable.
   
   Wait a few minutes while the machine's IP address is automatically set.

Wireless LAN

The example described in this document is for the <SSID Settings>. See the User's Guide for information on other configuration procedures.

1. Check the router's "SSID" and "Network key".
   

2. Select <Wireless LAN>.
3. Check the message and press.
4. Select <SSID Settings>.
5. Select <Select Access Point>.
6. Select the router with the matching SSID.
   If the <Apply settings of IEEE 802.1X Settings to the connection?> message appears, select <Yes> and proceed to step Specifying the Network Settings below.

7. Enter the network key you checked above and select <Apply>.
8. Select <Yes>.
   Once a connection is established, the home screen appears.

Installing the Software/Drivers

Install the software and drivers from the CD/DVD-ROM included, or visit the URL below and download them from the Canon website for your country/region. https://global.canon/en/support/

Example: LBP722Cx download

Documents / Resources

References

• For Product and Support Information | Canon Global

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Canon image CLASS, LBP720 Series Manual