Ieee 802.1P/Q - Polycom SoundPoint IP 300 Administrator's Manual

Administrator's Guide - SoundPoint
set to a value from 0 through 7. The type of service can be configured specifically for
RTP packets and call control packets, such as SIP signaling packets.
Central
(boot
server)
Local

4.5.2 IEEE 802.1p/Q

The phone will tag all Ethernet packets it transmits with
of the following reasons
• When it has a valid VLAN ID set in its network configuration
• When it is instructed to tag packets through Cisco Discovery Protocol (CDP)
• When a VLAN ID is obtained from DHCP (refer to 2.2.1.3.2 DHCP Menu on
The 802.1p/Q user_priority field can be set to a value from 0 to 7. The user_priority
can be configured specifically for RTP packets and call control packets, such as SIP
signaling packets, with default settings configurable for all other packets.
Central
(boot
server)
Local
82
®
IP / SoundStation
Configuration file:
sip.cfg
Web Server
(if enabled)
Local Phone User
Interface
:
running on a connected Ethernet switch
page 9)
Configuration file:
sip.cfg
Web Server
(if enabled)
Local Phone User
Interface
Copyright © 2006 Polycom, Inc.
®
IP
Specify protocol-specific IP TOS settings.
• For more information, refer to 4.6.1.9.2 IP TOS <IP/> on
page 119.
Specify IP TOS settings.
Navigate to: http://<phoneIPAddress>/netConf.htm#qo
None.
Specify default and protocol-specific 802.1p/Q settings.
• For more information, refer to 4.6.1.9.1 Ethernet IEEE
802.1p/Q <Ethernet/> on page 118.
Specify 802.1p/Q settings.
Navigate to http://<phoneIPAddress>/netConf.htm#qo
Specify whether CDP is to be used or manually set the VLAN
ID or configure DHCP VLAN Discovery.
Phase 1: bootRom - Navigate to: SETUP menu during auto-
boot countdown.
Phase 2: Application - Navigate to: Menu>Set-
tings>Advanced>Admin Settings>Network Configuration
• For more information, refer to 2.2.1 Basic Network Setup
on page 5.
Optimization
an 802.1Q VLAN header for one