Network; Setting The Tcp/Ip Protocol (Ipv4) - Toshiba E-STUDIO287CS User Manual

NETWORK

You can set various network functions.
Memo
• For instructions on how to display the NETWORK menu,
see the following page:

P.261 "Accessing the Admin Menu"

P.279 "Setting the TCP/IP protocol (IPv4)"

P.280 "Setting the TCP/IP protocol (IPv6)"

P.284 "Setting the IPX/SPX protocol"

P.284 "Setting the NetWare settings"

P.285 "Setting the SMB protocol"

P.286 "Setting the AppleTalk protocol"

P.287 "Setting the HTTP network service"

P.287 "Setting the Ethernet speed"

P.287 "Setting the LDAP services and the filtering
functions"

P.288 "Setting IPsec (IP security)"

P.288 "Checking the network"
Note
• When performing network settings, you are required to
press [APPLY NOW] after changing the settings to initialize
the NIC. Pressing [APPLY NOW] displays the message
"NETWORK INITIALIZING" at the lower left of the screen in
a few seconds. The time for this message to appear differs
depending on the setting.
This message disappears when the setting is complete.

Setting the TCP/IP protocol (IPv4)

You can set the TCP/IP protocol that is commonly used in most
network systems. When using Web-based utilities such as
TopAccess and e-Filing, or network features of this equipment
such as network printing, network scanning, and Internet Fax,
you are required to set the TCP/IP protocol.
In the TCP/IP setting operation, you can select the addressing
mode, as well as assign the IP address, subnet mask and
default gateway (when manually assigned).
How the TCP/IP protocol must be set depends on your network
environment.
- 279 -
SETTING ITEMS (ADMIN)
1
2
3
4
5
6
7