Adjusting The Accelerator Pedal Free Play - Yamaha Wolverine YX70EPNG Service Manual

3. Remove:
• Center storage compartment
Refer to "GENERAL CHASSIS (3)" on page
4-6.
4. Adjust:
• Parking brake lever free play
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Release the parking brake lever.
b. Slide back the rubber cover "1".
c. Loosen the locknut "2".
d. Turn the adjusting nut "3" in direction "a" or "b"
until the correct free play is obtained.
TIP
If there is any brake drag of the parking brake,
turn the adjusting nut in direction "a". If there is
free play, turn the adjusting nut in direction "b".
e. Tighten the locknut to specification.
Parking brake cable locknut
16 Nm (1.6 m·kgf, 12 ft·lbf)
f. Slide the rubber cover to its original position.
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
5. Install:
• Center storage compartment
Refer to "GENERAL CHASSIS (3)" on page
4-6.
a
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
3
1
a
b
2
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
PERIODIC MAINTENANCE
EBS30054
ADJUSTING THE ACCELERATOR PEDAL
FREE PLAY
1. Check:
• Accelerator pedal free play "a"
Out of specification → Adjust.
▼▼▼
2. Remove:
• Side cover (left)
• Rear panel (left)
Refer to "GENERAL CHASSIS (1)" on page
4-1.
• Center storage compartment
Refer to "GENERAL CHASSIS (3)" on page
4-6.
3. Adjust:
• Accelerator pedal free play
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Remove the throttle cable housing cover "1".
b. Slide back the rubber cover "2".
c. Loosen the locknut "3".
▲▲▲
d. Turn the adjusting nut "4" in direction "a" or "b"
until the specified accelerator pedal free play
is obtained.
Direction "a"
Accelerator pedal free play is in-
creased.
Direction "b"
Accelerator pedal free play is de-
creased.
3-22
Accelerator pedal free play
12.0–32.0 mm (0.47–1.26 in)
a
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
1