Adjusting The Brake Pedal; Lubricating The Brake Pedal And Accelerator Pedal; Adjusting The Parking Brake - Yamaha Wolverine YX70EPNG Service Manual

6. Check:
• Brake hose holders
Loose → Tighten the holder bolts.
Damage → Replace.
7. Apply the brake several times.
8. Check:
• Brake hoses
• Brake pipe
Brake fluid leakage → Replace any damaged
hose and pipe.
Refer to "FRONT AND REAR BRAKES" on
page 4-27.
9. Install:
• Center storage compartment
Refer to "GENERAL CHASSIS (3)" on page
4-6.
• Rear panel (left)
Refer to "GENERAL CHASSIS (1)" on page
4-1.
EBS30048

ADJUSTING THE BRAKE PEDAL

1. Check:
• Brake pedal free play "a"
Out of specification → Adjust.
Brake pedal free play
0 mm (0 in)
a
2. Adjust:
• Brake pedal free play
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Loosen the locknut "1".
b. Turn the brake pedal rod "2" in direction "a" or
"b" until the correct free play is obtained.
Direction "a"
Brake pedal free play is increased.
Direction "b"
Brake pedal free play is decreased.
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
PERIODIC MAINTENANCE
c. Tighten the locknut to specification.
EWB03090
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by plac-
ing a block under the frame, and spin the
front and rear wheels to ensure there is no
brake drag. If any brake drag is noticed per-
form the above steps again.
▲ ▲▲▲ ▲ ▲▲▲ ▲
EBS30049
LUBRICATING THE BRAKE PEDAL AND
ACCELERATOR PEDAL
Lubricate the pivoting point and metal-to-metal
moving parts of the pedal.
▼▼▼
EBS30478

ADJUSTING THE PARKING BRAKE

1. Place the vehicle on a level surface.
2. Check:
• Parking brake lever free play "a"
Out of specification → Adjust.
3-21
b
a
2
Brake pedal rod locknut
17 Nm (1.7 m·kgf, 12 ft·lbf)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
Recommended lubricant
Lithium-soap-based grease
Parking brake lever free play
0 mm (0 in)
1
▲ ▲▲▲ ▲ ▲▲▲