Removing The Wheels; Removing The Wheel Hubs; Checking The Wheels - Yamaha Wolverine YX70EPNG Service Manual

EBS30083

REMOVING THE WHEELS

1. Place the vehicle on a level surface.
2. Elevate:
• Wheels
TIP
Place the vehicle on a suitable stand so that the
wheels are elevated.
EBS30084

REMOVING THE WHEEL HUBS

The following procedure applies to all of the
wheel hubs.
1. Straighten the wheel axle nut rib "a".
2. Remove:
• Wheel axle nut
3. Remove:
• Brake caliper
TIP
Do not apply the brake pedal when removing the
brake caliper.
4. Remove:
• Wheel hub "1"
TIP
Use a general puller "2" to separate the wheel
hub and constant velocity shaft.
1
EBS30085

CHECKING THE WHEELS

The following procedure applies to all of the
wheels.
1. Check:
• Tire
FRONT AND REAR WHEELS
• Wheel
Refer to "CHECKING THE TIRES" on page
3-25 and "CHECKING THE WHEELS" on
page 3-24.
EWB03020
After replacing the tire, ride conservatively to
allow the tire to be properly seated in the rim.
Failure to do so may cause an accident re-
sulting in vehicle damage and possible inju-
ry.
a
2. Measure:
• Radial wheel runout "1"
• Lateral wheel runout "2"
Over the specified limit → Replace the wheel
or check the wheel bearing play.
Refer to "CHECKING THE STEERING
KNUCKLES AND FRONT WHEEL BEAR-
INGS" on page 4-53 and "CHECKING THE
REAR KNUCKLES AND REAR WHEEL
BEARINGS" on page 4-62.
2
4-24
WARNING
Front wheel
Radial wheel runout limit
2.0 mm (0.08 in)
Lateral wheel runout limit
2.0 mm (0.08 in)
Rear wheel
Radial wheel runout limit
2.0 mm (0.08 in)
Lateral wheel runout limit
2.0 mm (0.08 in)