Yamaha Wolverine YX70EPNG Service Manual page 73

1. Horn lead (except for CDN)
2. Headlight lead (left)
3. Throttle cable
4. Brake light switch lead
5. Radiator inlet hose
6. Wire harness
7. EPS torque sensor lead (for EPS models)
8. EPS motor lead (for EPS models)
9. Radiator fan motor breather hose
10. Radiator fan motor lead
11. Coolant reservoir hose
12. Differential assembly breather hose
13. Coolant reservoir breather hose
A. Fasten the left headlight lead to the frame with the
plastic band.
B. Fasten the right headlight lead and horn lead
(except for CDN) with the holder on the electrical
components tray.
C. Fasten the throttle cable and brake light switch
lead with the holder.
D. Fasten the radiator fan motor lead with the holder
on the radiator fan motor cover.
E. Fasten the coolant reservoir hose with the holder
on the radiator fan cover.
F. Fasten the throttle cable to the radiator inlet hose
with the plastic band. Be sure to route the throttle
cable to the outside of the radiator inlet hose.
G. Route the right headlight lead and horn lead
(except for CDN) through the slot in the electrical
components tray, and then fasten the leads with
the holder on the tray.
H. Route the differential assembly breather hose,
coolant reservoir breather hose, and radiator fan
motor breather hose through the hole in the
electrical components tray. Make sure that the end
of each breather hose protrudes from the electrical
components tray.
2-40
CABLE ROUTING