Yamaha Wolverine YX70EPNG Service Manual page 77

1. Radiator fan motor breather hose
2. Differential assembly breather hose
3. Coolant reservoir breather hose
4. Headlight lead (right)
5. Horn lead (except for CDN)
6. Radiator outlet hose
7. Differential motor lead
8. Coolant reservoir hose
9. Wire harness
10. Frame ground lead
11. Starter motor lead
12. Negative battery lead
A. Route the wire harness, starter motor lead,
negative battery lead, and horn lead (except for
CDN) into the electrical components tray.
B. Make sure that there is no slack in the coolant
reservoir breather hose in the area shown in the
illustration.
C. Fasten the right headlight lead and horn lead
(except for CDN) with the plastic band.
D. Fasten the coolant reservoir breather hose to the
radiator outlet hose with the holder at the location
shown in the illustration.
E. Fasten the wire harness, starter motor lead, and
negative battery lead with the plastic band.
F. Fasten the wire harness, starter motor lead, and
negative battery lead with the plastic band.
Position the plastic band at the section of the wire
harness where the leads branch off from the
harness.
G. Fasten the differential assembly breather hose with
the holder on the radiator fan motor cover.
H. Fasten the radiator outlet hose and radiator fan
motor lead with the plastic band.
I. Fasten the wire harness, starter motor lead, and
negative battery lead with the plastic band.
J. Fasten the differential motor lead with the holder.
Insert the projection on the holder into the hole in
the frame.
2-44
CABLE ROUTING