TIP
Press the spacer into the shift lever cover, mak-
ing sure that the slit "a" in the spacer is facing up-
ward as shown in the illustration.
2
6. Install:
• Oil seal "1"
New
(into the shift lever cover "2")
Installed depth "a"
1.0–1.5 mm (0.04–0.06 in)
7. Install:
• Shift arm "1"
TIP
Align the slit "a" in the shift arm with the projec-
tion "b" on shift lever 1.
1
a
a
1
New
1
New
a
2
b
5-48
EBS30444
ADJUSTING THE DRIVE SELECT LEVER
SHIFT ROD
EWB03060
NOTICE
Before moving the drive select lever, bring
the vehicle to a complete stop and take your
foot off the accelerator pedal. Otherwise, the
transmission may be damaged.
1. "N" (neutral)
2. "H" (high)
3. "L" (low)
4. "R" (reverse)
5. Drive select lever shift rod
1. Adjust:
• Drive select lever shift rod
▼
▼▼▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a. Make sure the drive select lever and trans-
mission are in "N" (neutral).
b. Loosen both locknuts "1".
ECB02460
NOTICE
The drive select lever shift rod locknut (drive
select lever side) has left-handed threads. To
loosen the locknut, turn it clockwise.
c. Turn the main switch to "ON", and then adjust
the length "a" of the shift rod to the drive se-
lect lever can be shifted to each shift position
and that the appropriate indicator light comes
on when the lever is in each position.
1
d. Tighten the locknuts.
SHIFT LEVER
1 2 3
4
5
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
a
1
▼▼▼