Yamaha Wolverine YX70EPNG Service Manual page 83

1. Horn lead (except for CDN)
2. Radiator outlet hose
3. Headlight lead (right)
4. Auxiliary DC jack lead
5. Meter assembly lead
6. Indicator light assembly lead
7. Parking brake switch lead
8. Throttle cable
9. Horn switch lead (except for CDN)
10. Main switch lead
11. On-Command four-wheel-drive switch lead
12. Light switch lead
13. Brake light switch lead
14. EPS motor lead (for EPS models)
15. Headlight lead (left)
16. Radiator inlet hose
A. To the electrical components tray
B. Fasten the wire harness with the plastic band.
Position the plastic band at the section of the wire
harness where the leads branch off from the
harness.
C. Fasten the wire harness and horn lead (except for
CDN) at the white mark on the harness with the
plastic band.
D. Fasten the throttle cable with the plastic band.
E. Fasten the wire harness and EPS motor lead (for
EPS models) with the plastic band. Position the
plastic band at the section of the wire harness
before the leads branch off from the harness.
F. Fasten the EPS torque sensor lead (for EPS
models), EPS motor lead (for EPS models), and
brake light switch lead with the holder.
G. Route the EPS torque sensor lead and EPS motor
lead through the hole in the electrical components
tray, and then connect the couplers to the EPS
control unit. (For EPS models)
2-50
CABLE ROUTING