Instrument Functions - Yamaha Wolverine YX70EPNG Service Manual

EBS30008

INSTRUMENT FUNCTIONS

Multi-function meter unit
3
2
1
7
1. "CLOCK" button
2. "RESET" button
3. "SELECT" button
4. Speedometer
5. Fuel meter
6. Clock/Hour meter/Voltage display
7. Odometer/Tripmeter A/Tripmeter B
The multi-function meter unit is equipped with
the following:
• a speedometer
• an odometer
• two tripmeters (which show the distance trav-
eled since they were last set to zero)
• a clock
• an hour meter (which shows the total time the
engine has been running)
• a voltage display (which shows the battery volt-
age)
• a fuel meter
• a self-diagnosis device
Odometer and tripmeter modes
1
2
3
1. "SELECT" button
2. "RESET" button
3. Odometer/Tripmeter A/Tripmeter B
4 5
6
Pushing the "SELECT" button switches the dis-
play between the odometer mode "ODO" and
the tripmeter modes "TRIP A" and "TRIP B" in
the following order:
ODO → TRIP A → TRIP B → ODO
To reset a tripmeter, select it by pushing the "SE-
LECT" button, and then push the "RESET" but-
ton for at least three seconds. The tripmeters
can be used to estimate the distance that can be
traveled with a full tank of fuel. This information
enables you to plan future fuel stops.
TIP
To switch the display between "mph" and "km/h",
turn the main switch to "
hold the "SELECT" button while turning the main
switch to " " (on).
Clock, hour meter and voltage display
modes
1
2
3
1. "SELECT" button
2. "RESET" button
3. "CLOCK" button
4. Clock/Hour meter/Voltage display
Pushing the "CLOCK" button switches the dis-
play between the clock mode "CLOCK", the hour
meter mode "HOUR", and the voltage display
mode " " in the following order:
CLOCK → HOUR →
To set the clock:
1. Set the display to the clock mode.
2. Push the "SELECT" button and "RESET" but-
ton together for at least three seconds.
3. When the hour digits start flashing, push the
"RESET" button to set the hours.
4. Push the "SELECT" button, and the minute
digits will start flashing.
5. Push the "RESET" button to set the minutes.
6. Push the "SELECT" button, and then release
it to start the clock.
1-5
FEATURES
" (off), then push and
4
→ CLOCK