Disassembling The Universal Joints; Disassembling The Front Constant Velocity Shaft Assemblies - Yamaha Wolverine YX70EPNG Service Manual

Hide thumbs Also See for Wolverine YX70EPNG:

Table of Contents

FRONT CONSTANT VELOCITY SHAFT ASSEMBLIES, DIFFEREN-

DISASSEMBLING THE UNIVERSAL JOINTS

• Universal joint

a. Remove the circlips "1"

b. Place the universal joint in a press.

c. With a suitable diameter pipe "2" beneath the

universal joint yoke "3", press the bearing "4"

into the pipe as shown.

It may be necessary to lightly tap the universal

joint yoke with a punch.

d. Repeat the steps for the opposite bearing.

e. Remove the universal joint.

DISASSEMBLING THE FRONT CONSTANT

VELOCITY SHAFT ASSEMBLIES

The following procedure applies to both of the

front constant velocity shaft assemblies.

• Boot bands

• Double offset joint "2"

• Circlip "3"

• Ball bearing "4"

• Dust boot "5"

Before removing the clip, slide the dust boot

away from the double offset joint.

TIAL ASSEMBLY AND FRONT DRIVE SHAFTS

A. Differential side

• Boot bands "1"

Use the boot band installation tool "2".

B. Wheel side

• Constant velocity joint

Secure the constant velocity shaft in a vise, and

then remove the constant velocity joint using

Boots band installation tool

Boots band installation tool

Table of Contents