Yamaha Wolverine YX70EPNG Service Manual page 193

3. Bends the lock washer "a".
4. Install:
• Dust boots
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Fit the tabs "a" into the holes "b" in the boot
band "1".
b. Crimp the portion "c" of the boot band with the
boots band installation tool "2".
Boots band installation tool
90890-01526
Boots band installation tool
YM-01526
2
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
5. Install:
• Steering assembly "1"
Steering assembly bolt
48 Nm (4.8 m·kgf, 35 ft·lbf)
a
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a
1
b
c
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
TIP
Tighten the steering assembly bolts in the prop-
er tightening sequence as shown.
▼▼▼
6. Install:
• Steering joint "1"
• Steering column "2" (except for EPS models)
• EPS unit "2" (for EPS models)
TIP
• Align the alignment mark "a" on the steering
assembly shaft and the slit "b" in the steering
joint with the alignment mark "c" on the steering
assembly housing.
• Fit the steering joint onto the steering column
shaft or EPS unit shaft so that the bolt hole "d"
in the joint is aligned with the area "e" on the
shaft that does not have splines.
▲▲▲
4-50
STEERING SYSTEM
FWD
4
1
1
Steering column bolt (except for
EPS models)
21 Nm (2.1 m·kgf, 15 ft·lbf)
EPS unit bolt (for EPS models)
21 Nm (2.1 m·kgf, 15 ft·lbf)
Steering joint bolt
33 Nm (3.3 m·kgf, 24 ft·lbf)
c a b
2
3
1