Adjusting The Gear Position Sensor - KTM RC 250 R Owner's Manual

19 EMS COMPONENTS
–
Transfer the sensor value reading plus 2 bits into the TPS_MIN field.
–
Fully open the throttle valve. Read out the sensor value in the REAL_TIME_TPS field and transfer the maximum value reading minus
2 bits into the TPS_MAX field.
–
Set End of Line transfers the calibrated values to the engine control unit.
Info
When the throttle position sensor is replaced due to fault, the new throttle position sensor must be positioned over the slot-
ted hole of the fixing screw such that a sensor value of 60 bits (±1 bit) results when the throttle valve is fully closed. After
that, make the settings as described.
19.3

Adjusting the gear position sensor

Info
The gear position sensor has two slotted holes by means of which the position can be adjusted. If the gear position sensor is
removed, the position must be readjusted.
–
Engage neutral gear.
–
Connect the engine control unit with the computer (see the MAYA Instructions on the CD-ROM in the separate enclosure).
–
In the MAYA software, select open EOL setting window.
L00566-10
L00565-01
74