KTM RC 250 R Owner's Manual page 71

18 SERVICE WORK ON THE ENGINE
–
Remove the cooling air guide, radiator hoses, and radiator.
–
Remove the main silencer, connecting pipe, and exhaust pipe.
–
Remove the sprocket.
–
Remove the shift linkage.
–
Disconnect the ground wire and all plug-in connections.
–
Remove the front air intake.
–
Pull off the engine breather hose.
–
Loosen the hose clip of the throttle valve body and pull off the throttle valve body.
The throttle valve body can remain on the vehicle.
–
Remove the thrust bearing of the clutch cable and detach the clutch cable from the
eyelet of the clutch release lever.
Main work
–
Support the engine with the scissors stand.
–
Remove the front engine bracket screw
L00662-11
–
Remove the front engine bracket screw
L00663-11
–
Remove nut
L00664-14
–
Remove the lower engine bracket screw
6
spacer
L00666-11
–
Remove the upper engine bracket screw
engine spacer
L00665-11
3 and nut 4 with the washers.
by approx. ten rotations.
8 by approx. ten rotations.
1
with the washer.
2
with the washer.
5
and loosen the lower adjustable engine
7
and loosen the upper adjustable
69