KTM RC 250 R Owner's Manual page 73

18 SERVICE WORK ON THE ENGINE
–
Pull out the upper engine bracket screw
adjustable engine spacer
Guideline
Screw, engine spacer
–
Mount the upper engine bracket screw
L00665-10
–
Pull out the lower engine bracket screw
adjustable engine spacer
Guideline
Screw, engine spacer
–
Mount the lower engine bracket screw
L00666-10
–
Mount and tighten nut
Guideline
Screw, rear engine bearer
–
Mount and tighten nut
Guideline
Screw, rear engine bearer
L00664-13
–
Tighten the front engine bracket screw
Guideline
Screw, front engine bearer
L00662-10
–
Tighten the front engine bracket screw
Guideline
Screw, front engine bearer
L00663-10
Finishing work
–
Attach the clutch cable to the eyelet of the clutch release lever and mount the
thrust bearing of the clutch cable.
–
Position the throttle valve body and mount the hose clip of the throttle valve body.
–
Mount the engine breather hose.
–
Mount the front air intake.
–
Connect the ground wire and all plug-in connections.
–
Mount the shift linkage.
–
Mount the sprocket.
5
slightly and tighten the upper
1 .
M16x1 10 Nm
(7.4 lbf ft)
5
.
6
slightly and tighten the lower
1
.
M16x1 10 Nm
(7.4 lbf ft)
6 .
9
with the washer.
M10 35 Nm
(25.8 lbf ft)
bk
with the washer.
M10 35 Nm
(25.8 lbf ft)
7
.
M10 35 Nm
(25.8 lbf ft)
8
.
M10 35 Nm
(25.8 lbf ft)
71
Thread greased
Thread greased
Thread greased
Thread greased
Thread greased
Thread greased