Checking Rear Brake Fluid Level - KTM RC 250 R Owner's Manual

12 BRAKE SYSTEM
12.7

Checking rear brake fluid level

Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
–
Remove cotter pin
–
Clean the brake caliper.
L00496-11
–
Insert the brake linings
L00496-12
–
Operate the hand brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
–
Add brake fluid to the MAX level.
Brake fluid DOT 5.1 (
–
Mount and tighten screw cap
Info
Clean up overflowed or spilt brake fluid immediately with water.
L00519-10
–
Stand the vehicle upright.
–
Check the brake fluid level of the brake fluid reservoir.
»
If the fluid level reaches the MIN marking
–
Add rear brake fluid.
L00539-10
3 4
, pull out pin , and remove the brake linings.
5 4
, insert pin , and mount cotter pin
p. 94)
1
with membrane
1
( p. 49)
x
3
.
2
and the O-ring.
:
48