Riding Instructions; Checks And Maintenance Measures When Preparing For Use; Starting - KTM RC 250 R Owner's Manual

8

RIDING INSTRUCTIONS

8.1

Checks and maintenance measures when preparing for use

Info
Before every trip, check the condition of the vehicle and ensure that it is safe to operate.
The vehicle must be in perfect technical condition when it is being operated.
–
Check the engine oil level. (
–
Check the front brake fluid level. (
–
Check the rear brake fluid level. (
–
Check the front brake linings. (
–
Check the rear brake linings. (
–
Check the brake system.
–
Check the coolant level. (
–
Check the chain for dirt. (
–
Check the chain tension. (
–
Check the tire condition. (
–
Check the tire pressure. (
–
Warm the tires to the operating temperature with a tire warmer.
Guideline
Tire temperature
–
Check the settings of all controls and ensure that the controls can be operated smoothly.
–
Check that the electrical equipment is functioning properly.
–
Check the fuel level.
–
Check the fuel overflow reservoir. (
–
Check the coolant overflow reservoir. (
8.2

Starting

Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an enclosed
space without an effective exhaust extraction system.
Caution
Danger of accidents If the vehicle is operated with a discharged battery or without a battery, electronic components and safety
equipment may be damaged.
–
Never operate the vehicle with a discharged battery or without a battery.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
p. 66)
p. 45)
p. 48)
p. 46)
p. 50)
p. 61)
p. 42)
p. 43)
p. 54)
p. 55)
p. 41)
p. 42)
–
Place the starter on a non-slip surface.
Info
Follow the operating instructions of the starter.
–
Engage neutral gear and place the motorcycle on the starter.
–
Switch on the ignition.
After you switch on the ignition, you can hear the fuel pump working for about
two seconds. The function check of the combination instrument is run at the
same time.
L00556-01
–
Depending on the starter in use, engage either first or second gear.
–
Pull the clutch and the front brake and switch on the starter.
78... 80 °C (172... 176 °F)
20