Combination Instrument 2/2 - KTM RC 250 R Owner's Manual

6 CONTROLS
6.12

Combination instrument 2/2

Press the Select button to enter the signal
input setting screen.
EX. Now the piston setting is changed from
1 P (Piston) to 4 P (Pistons).
EX. To change the setting to L
(The negative impulse)
Press the Adjust button to choose the input
signal you want to set.
EX. Now the setting is Hi (The positive impulse)
Now the input signal setting is flashing!
Press the Select button to enter the shift light
setting screen.
EX. Now the input signal is changed from hight
to low.
EX. The shift light set on 9,500 RPM.
Press the
you want to set.
EX. Now the RPM shift light setting is 9,000 RPM.
The digit you could set is flashing now .
P.S. P.S.
If you set the RPM shift light at 9,500 RPM, the yellow light (Pre-shift
light) will light on at 8,000 RPM.
And the red light (Shift light) will light on when it reaches 9,500 RPM.
Press the Adjust button to change the setting
digit.
Press the Select button to enter the pre-shift
light setting screen.
EX. Now the shift light setting is changed from
9,000 RPM to 9,500 RPM.
EX. The pre-shift RPM set
(It means that the pr e-shift light will light on
1,500 RPM before the shift light.)
Press the Select button to move to the digit
you want to set.
EX. Now the RPM pr e-shift light setting is -1,000
RPM.
o.
The input signal setting range is
between hight (The positive signal) &
low (The negative signal)
If the tachometer can't detect
signal (No RPM is displayed on the
screen), you could choose another
setting, and check it again.
Select button to move to the digit
Pre-shift light (-1,500 RPM) Shift light (9,500 RPM)
Setting range: 5,000~16,000 RPM
Setting unit:100 RPM
on 8,000 RPM.
the
P.S. P.S.
The temperature light
will light on when the
temperature reached your
setting.
Press the Adjust button to change the setting
digit.
Setting range: -500~-5,000 RPM.
Setting unit: 100 RPM.
Press the Select button to enter the over heat
warning light setting screen.
EX. Now the pre-shift light setting is changed
from 1,000 RPM to 1,500 RPM.
EX. The over heat warning set on 105 C.
Press the Select button to move to the digit
you want to set.
EX. Now the over heat warning setting is
o
10 0.0 C .
Press the Adjust button to change the setting
digit.
o
Setting range: 60~15 0 C ( 140~302
o o
S etting unit: 1 C (1 F).
The digit you could set is flashing now .
The setting unit will change together with the
temperature unit setting.
Press the Select button to back the main
screen.
EX. Now the setting is changed from 100
o
to 105 C.
Main screen.
16
o
o
o
C
L00581-01