Removing A Sas Hard Disk Drive - IBM Flex System p260 Installation And Service Manual

Figure 16. Installing the bezel assembly in an IBM Flex System p460 Compute Node
To replace a bezel on the compute node, complete the following steps:
Procedure
1. Align the bezel with the compute node according to the circled locations indicated in Figure 15 on
page 45 and Figure 16.
2. Align the bezel assembly with the front of the compute node. Firmly press the bezel at the sides
where the two pins protrude from the face of the compute node until the assembly clicks into place.
3. Install the compute node into the IBM Flex System Enterprise Chassis. See "Installing the compute
node in an IBM Flex System Enterprise Chassis" on page 93.

Removing a SAS hard disk drive

If the serial-attached SCSI (SAS) hard disk drive is damaged or in need of replacing, you can remove it
from the compute node.
46
Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide