Failing Function Codes - IBM Flex System p260 Installation And Service Manual

Failing function codes:

Failing function codes (FFCs) identify a function within the system unit that is failing.
Table 16 describes the component that each function code identifies.
Note: When replacing a component, perform system verification for the component. See "Using the
diagnostics program" on page 455.
Table 16. Failing function codes
FFC Description and notes
151
1. Battery
Note: After replacing the battery:
a. Set the time and date.
b. Set the network IP addresses (for compute nodes that start up from a network).
2. System-board and chassis assembly
152 System-board and chassis assembly
166 Check the event log for an IBM Flex System Enterprise Chassis blower or fan fault. See the
documentation that comes with the IBM Flex System Enterprise Chassis.
199 System-board and chassis assembly
210 System-board and chassis assembly
212 System-board and chassis assembly (cache problem)
214 System-board and chassis assembly
217 System-board and chassis assembly
219 Common memory logic problem for memory DIMMs.
Note: If more than one pair of memory DIMMs are reported missing:
1. Replace the memory DIMM at the physical location code that is reported.
2. Replace the system board.
221 System-board and chassis assembly
226 System-board and chassis assembly
227 System-board and chassis assembly
241 Ethernet network problem
282 System-board and chassis assembly
292 System-board and chassis assembly (host to PCI bridge problem)
293 System-board and chassis assembly (PCI to PCI bridge problem)
294 System-board and chassis assembly (MPIC interrupt controller problem)
296 PCI device or adapter problem.
Note: The replacement part can only be identified by the location code reported by diagnostics.
2C4 System-board and chassis assembly
2C7 System-board and chassis assembly (memory controller)
2C8 System-board and chassis assembly
2C9 System-board and chassis assembly
2D2 System-board and chassis assembly (bus arbiter problem)
2D3 System-board and chassis assembly
2D4 System-board and chassis assembly (System/SP interface logic problem)
2D5 System-board and chassis assembly (I2C primary)
446
Power Systems: IBM Flex System p260 and p460 Compute Nodes Installation and Service Guide