Removing A Sas Hard Disk Drive - IBM BladeCenter HS21 Series Problem Determination And Service Manual

4. If a Memory and I/O Expansion Blade is installed, remove it (see "Removing an
5. Install the cover onto the blade server.
6. Install the blade server into the BladeCenter unit.

Removing a SAS hard disk drive

To remove a SAS hard disk drive, complete the following steps.
Hard disk drive
release lever
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
3. Remove the blade server cover (see "Removing the blade server cover" on
4. If a Memory and I/O Expansion Blade is installed, remove it (see "Removing an
5. Locate the hard disk drive that is to be removed (SAS ID 0 or SAS ID 1).
6. While pulling the blue release lever at the front of the hard disk drive tray, slide
7. To remove the drive tray, remove the four screws that secure it to the system
8. If you are instructed to return the hard disk drive, follow all packaging
expansion unit" on page 82).
SAS ID 1
SAS ID 0
Hard disk
drive release
lever
on page 75.
the blade server from a BladeCenter unit" on page 77).
page 80 for instructions).
expansion unit" on page 82).
the drive forward to disengage it from the connector at the rear of the drive tray:
then, lift the drive out of the drive tray.
board and lift it out of the blade server.
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 4. Removing and replacing blade server components
85