Change Usb No. Return Value (Function Code: 45); Change Usb No. Return Value - Brother DCP-1510 Service Manual

1.3.12 Change USB No. return value (function code: 45)

Change USB No. return value

<Function>
When the operating system (OS) installed on the computer is Windows Vista
machine is connected to this computer using USB2.0FULL, the OS may not be able to obtain
the USB device serial number depending on the computer and USB device. If the serial
number cannot be obtained, the number of devices increases each time the device is
connected to the computer. To avoid this problem, setting this function to "USBNo.=ON" can
fix the USB No. return value to "0".
LCD
USBNo. = ON
USBNo. = OFF
The setting currently selected is marked "*" at the end of the display.
<Operating Procedure>
(1) Ten-key pad models
Press the [4] and [5] buttons in this order in the initial state of maintenance mode.
Non-ten-key pad models
Press the [
[OK] button.
(2) "USBNo." is displayed on the LCD. Press the [Start] button.
(3) "USBNo.=ON" is displayed on the LCD. Press the [
"USBNo.=ON" when fixing the serial number return value to "0" or "USBNo.=OFF" when
not fixing it.
(4) Press the [Start] button. "Accepted" is displayed on the LCD, and the machine returns to
the initial state of maintenance mode.
(5) Turn OFF the power switch.
Note:
• The setting is applied after the power switch is turned OFF and then ON again.
Return the serial number of the machine. (Default)
Return "0".
] or [ ] button to display "MAINTENANCE 45" on the LCD and press the
Description
] or [
4-21
®
, and the
] button to display
Confidential