Brother DCP-1510 Service Manual page 117

(2) Remove the screw pan (S/P washer) M3.5x6 screw to release the ground harness.
(3) Remove the low voltage power supply PCB unit from the machine.
(4) Disconnect the heater harness and the low voltage PCB harness from the low voltage
power supply PCB unit.
(5) Release the hook to remove the bushing from the machine.
Low voltage PCB harness
Notch
Low voltage power
supply PCB unit
Screw pan (S/P washer) M3.5x6
Harness routing: Refer to
/ fuser unit".
Assembling Note:
• When assembling the low voltage power supply PCB unit, engage the two notches of the
PCB with the two ribs of the machine.
• After the assembly, refer to
SUPPLY PCB UNIT" in chapter 3
Rib
Notch
Ground harness
Fig. 2-23
"1. Frame R / main PCB ASSY / low voltage power supply PCB unit
"4. IF YOU REPLACE THE LOW VOLTAGE POWER
to configure each setting.
2-27
Rib
Heater harness
Bushing
Hook
Confidential