Brother DCP-1510 Faq & Troubleshooting

Hide thumbs Also See for DCP-1510:

3.7.2018

DCP-1510

FAQs & Troubleshooting

Date: 08/04/2013 ID: faq00002256_019

Clean the Drum Unit.

1. Open the scanner cover. The pull-arm (1) on the left side of the machine will lock. Open the top cover.

2. Slowly take out the drum unit and toner cartridge assembly.

3. Push down the lock lever (1) and take the toner cartridge out of the drum unit (2).

4. Turn the drum unit gear by hand while looking at the surface of the drum roller (1).

http://support.brother.com/g/b/faqend.aspx?c=au&lang=en&prod=dcp1510_eu_as&faqid=faq00002256_019

Clean the Drum Unit. | Brother

1/4

Table of Contents

Do you have a question about the DCP-1510 and is the answer not in the manual?

Page 1 3.7.2018 Clean the Drum Unit. | Brother DCP-1510 FAQs & Troubleshooting Date: 08/04/2013 ID: faq00002256_019 Clean the Drum Unit. Follow the steps below to clean the drum unit: 1. Open the scanner cover. The pull-arm (1) on the left side of the machine will lock. Open the top cover.
Page 2 3.7.2018 Clean the Drum Unit. | Brother 5. Wipe the surface of the drum gently with a dry cotton swab until the dust of glue on the surface comes off. 6. Put the toner cartridge back into the drum unit until you hear it lock into place. If you put the cartridge in correctly, the lock lever on the drum unit will lift automatically.
Page 3 Go to the Top page in the FAQs & Troubleshooting section See other FAQs in this category Have you checked the manuals? Go to the Manuals section If you need further assistance, please contact Brother customer service: Go to the Contact Us section Related Models DCP-1510, MFC-1810 Content Feedback To help us improve our support, please provide your feedback below.