Adf Unit (Only For Models With Adf Unit) - Brother DCP-1510 Service Manual

7.3

ADF unit (only for models with ADF unit)

(1) Open the ADF unit.
(2) Disconnect the ADF sensor harness from the main PCB ASSY.
(3) Remove the taptite cup S M3x8 SR screw to release the ground harness of the ADF sensor
harness.
(4) Pull out the ADF sensor harness from the hole of the machine.
(5) Remove the two taptite bind B M4x12 screws to remove the ADF unit from the machine.
ADF unit
Taptite bind B M4x12
ADF sensor harness
Hole
Ground harness
Taptite cup S M3x8 SR
ADF sensor harness
Main PCB ASSY
Fig. 2-6
Harness routing: Refer to "1. Frame R / main PCB ASSY / low voltage power supply PCB unit
/ fuser unit".
2-15
Confidential