Brother DCP-1510 Service Manual page 47

Error code 6200
No Drum
Open the Scanner Cover and Top Cover, then install the Drum Unit.
Detected that the drum unit was not set by GRID current error.
<User Check>
• Set the drum unit correctly.
• Clean the electrodes of the drum unit.
Step
Dirt on the electrodes of the
1
drum unit
Dirt on the high voltage power
2
supply PCB terminal
Connection failure of the high
3
voltage PCB flat cable
High voltage power supply PCB
4
failure
5 Main PCB failure
Electrodes location of the toner cartridge and drum unit
Electrodes location of the machine
Cause
Clean the electrodes of the drum unit.
(Refer to
Clean the high voltage power supply PCB
terminal. (Refer to
Reconnect the high voltage PCB flat cable.
Replace the high voltage power supply PCB
ASSY.
Replace the main PCB ASSY.
Fig. 1-7
Fig. 1-8
1-30
Remedy
Fig. 1-7.)
Fig. 1-8.)
Confidential