Otto Bock VENTUS Instructions For Use Manual page 9

Hazards when overcoming obstacles
WARNING
Overcoming steps and obstacles without assistance
Tipping over, falling of the user due to failure to observe transportation instructions
► Always have accompanying persons help you negotiate steps and other obstacles.
► Use available facilities (e.g. access ramps or lifts).
► If such facilities are not available, have 2 assistants carry you over the obstacle.
WARNING
Improper lifting by attendants
Tipping over, falling of the user due to lifting by removable components
► Only lift the product by firmly mounted components (e.g. main frame, push handles).
► Be sure that the clamping levers of the height-adjustable push handles are firmly tightened.
Hazard in case of broken skin
CAUTION
Prolonged contact with broken skin
Reddening of the skin or pressure points due to contamination with germs or incorrectly adapted seat cushion
► Check before using the product that the skin is not broken in areas subject to prolonged pressure (e.g., but­
tocks, back and rear side of the thighs).
► In case of problems, please contact the qualified personnel who adjusted the product.
► No liability is assumed for injuries caused by the use of the product with broken skin.
Hazards due to fire, heat and cold
CAUTION
Extreme temperatures
Hypothermia or burns through contact with components, failure of components
► Do not expose the product to any extreme temperatures (e.g. direct sunlight, sauna, extreme cold).
Hazards due to improper use of the product
WARNING
Overloading
Severe injuries if the wheelchair tips over due to overloading, damage to the product
► Do not exceed the maximum load capacity (see the nameplate and section "Technical data").
► Please note that certain options and add-on components will reduce the remaining load capacity.
WARNING
Exceeding the service life
Serious injuries due to failure to observe the manufacturer's requirements
► Using the product beyond the specified expected service life (see Page 32) leads to increased residual risk
and should only take place subject to the due diligence and deliberations of qualified personnel.
► If the service life is reached, the user or a responsible attendant should contact the qualified personnel who
fitted the product or the manufacturer's servicing department (see inside rear cover or back page for
address). Here the user can obtain information about known risks and the current options for refurbishing the
product.
NOTICE
Use under incorrect environmental conditions
Damage to product due to corrosion or abrasion
► Do not use the product in salt water.
► Also avoid – if possible – sand or other dirt particles that may damage the wheel bearings.
Ventus
Safety
Ottobock | 9