14. Set the KBUMP site angle (with reference to SOUNDVISION simulations) by screwing both KJACK accessories
(see section 5.1).
15. Secure the system using ratchet straps or any applicable materials.
6.2.2
Disassembling the ground stacked array
1. Remove the ratchet straps or other securing materials.
2. On each KUDO
®
enclosure, remove both lower rear BLP.
KUDO_RM_ML_1.0
Figure 31: Setting the KBUMP site angle
Figure 32: Removing the lower rear BLP
w w w . l - a c o u s t i c s . c o m
EN
23 en
Need help?
Do you have a question about the kudo multi-mode wst and is the answer not in the manual?