Table of Contents
Advertisement
Available languages
Available languages
®
KUDO
MULTI-MODE WST
Rigging Procedures
VERSION 1.0
12. On each KUDO
®
enclosure, remove the dolly board by pulling on the captive BLP lanyards.
13. a. Slightly raise the stack and place one support base in position.
b. Use the base-supported KJACK to raise the stack and facilitate the placement of the second support base.
KUDO_RM_ML_1.0
®
SYSTEM
Figure 29: Pulling on the captive BLP lanyards
Figure 30: Placing the KJACK support bases in position
w w w . l - a c o u s t i c s . c o m
22 en
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the kudo multi-mode wst and is the answer not in the manual?