Table of Contents
Advertisement
● Pairing (For MiniZ MHS)
In order for the receiver to operate, it must store the
transmitter's unique ID in its memory in a process
called "pairing." Even if a single transmitter is used
to control multiple receivers, each receiver must go
through the pairing process with the transmitter
before being used for the first time.
※ Please adjust the modulation mode before pairing.
(p.24) A receiver does not work normally in a different
mode.
1.
Preparing the Transmitter
① While pushing the ET2 lever up, power on.
The pilot LED lights up, release ET2 lever.
PowerON
ET2
② Displays the initial screen, then pairing display is
shown. (indicating transmitter is transmitting the
pairing signal.)
<France mode pairing ＞
FRANCE mode pairing is possible when the ET2 lever is
released after LED turns off. Please use this feature if the
situation is needed.
2.
Preparing the Mini-Z
① Bring distance of EX-2 and MiniZ close to about
10cm.
10cm
② Switch on MiniZ while pushing the setup button
of Mini-Z.
Pushing setup button
③ After the Mini-Z's LED has lit up, release the
setup button. Then ｃ heck that the Mini-Z's LED
lights up again (indicating pairing completion)
3.
Preparations for Operation
① Switch off MiniZ.
② Switch off the EX-2 main power, then switch on
EX-2 again.
④ Bring distance of EX-2 and MiniZ close to about
30cm. Switch on the Mini-Z and check that the
receiver LED is lit. If the LED flashes, the Mini-Z
is not getting the EX-2 signal and the pairing
procedure should be repeated.
If the mode is changed（General or France), please
conduct pairing procedures with the Mini-Z you are using
again.
21
Switch on
LED
Hide quick links:
Advertisement
Table of Contents
