Installation Of Xpansion Unit - Ko Propo EX-2 Instruction Manual

● Installation of Xpansion unit
Xpansion unit can be mounted facing the
front or the side. The factory setting is
mounted to the front.
Be careful to not misuse the M2.6-6BH and TP2.6-
8BH screws.
Xpansion unit can be mounted in two different
P
directions using the monitor base and bracket..
A ▼：setting to the front
① Attach a monitor base parallel to Xpansion
unit. ※ Factory setting.
Attention to the marker.
M2.6-6BH
x 2
② Attach the monitor bracket to the master
unit.
※［A ▼］mark to the steering side
TP2.6-8BH
Self tapping screws
x ４
Connect the wire of the
Xpansion unit to the
master unit.
③ Attach expansion unit to a master unit.
While matching the edge of the base with
the dent of the bracket, slide it until the
Xpansion unit locks.
▼ B：when mounting sideways
① Attach the monitor base at a right angle to
Xpansion Unit. ※ Different Factory setting.
M2.6-6BH
x 2
② Attach the monitor bracket to the master
unit. ※ Apply ［B ▼］ mark to the steering side
TP2.6-8BH
Self tapping screws
x ４
Connect the wire of the
Xpansion unit to the
master unit.
③ Attach the Xpansion unit to the master unit.
※ Attach the monitor base and bracket as
shown in figure A ③ .
A
How to disassemble the Xpansion unit.
1.While pushing the monitor-based apart.
2.Slide the Xpansion like shown in the figure
below and take off.
※ The disassembly method is the same as side
and front positions.
When assembling or disassembling the Xpansion unit to
EX-2, please switch off the EX-2.
17
Attention to the marker.
1 2
B