MNT
1
3
å
2
4
a
∫
4
å F50D
∫ FT50C
TIP:
Mark a the trim tab 2 at the area shown,
and then remove it.
4. Place the lower unit in water, and then
start the engine.
5. Check for water flow at the cooling water
pilot hole. If there is no water flow, check
the cooling water passages inside the
outboard motor.
10-11
Maintenance
1
a
2
Checking the top cowling
1. Check the fitting by pushing the cowling
with both hands. Adjust if there is free
play.
2. Loosen the bolts 1.
3. Move the hook 2 up or down slightly to
adjust its position.
TIP:
To tighten the fitting, move the hook 2 in
9
direction a.
To loosen the fitting, move the hook 2 in
9
direction b.
4. Tighten the bolts 1.
b
1
2
a