å
∫
Predelivery check / General periodic maintenance
ç
∂
å D model
∫ PTT model
ç F50D
∂ FT50C
TIP:
9
Replace the anodes if excessively eroded.
In addition, check the ground lead.
9
If it is necessary to disassemble the out-
board motor to check an anode, refer to the
applicable disassembly procedure in this
manual.
Checking the battery
1. Check the battery. See "Checking the
battery" (10-4).
Checking the cooling water passage
1. Remove the cooling water inlet covers 1
and trim tab 2.
2. Check the cooling water inlet covers and
cooling water inlets. Clean if clogged.
3. Install the cooling water inlet covers 1
and trim tab 2, and then tighten the
screw 3 and bolt 4 to the specified
torque.
0
1
2
3
4
5
6
7
8
9
10
A
10-10