Flushing Device; Installing Top Cowling - Yamaha XF375 Owner's Manual

EMU40994
Engine oil
1. Place the outboard motor in a vertical position (not tilt-
ed). NOTICE: If the outboard motor is not level, the
oil level indicated on the oil dipstick may not be ac-
curate.
[ECM01862]
2. Remove the oil dipstick and wipe it clean.
1
1. Oil dipstick
3. Insert the oil dipstick completely and remove it again.
4. Check that the oil level on the oil dipstick is between the
upper and lower marks. Consult your Yamaha dealer if
the oil level is not at the proper level or if it appears milky
or dirty.
2
3
1. Oil dipstick
2. Upper mark
3. Lower mark
EMU40412
Outboard motor
 Check that the outboard motor is mounted properly and
check the outboard motor mounting bolts for looseness.
 Check the propeller for damage.
 Check for engine oil leaks.
EMU36494

Flushing device

Check that the flushing device's garden hose connector is
securely screwed on to the fitting on the bottom cowling.
NOTICE: If the garden hose connector is not properly
connected, cooling water can leak out and the engine
can overheat during operation.
1
[ECM01802]
1
1. Flushing device
2. Fitting
3. Garden hose connector
EMU47570

Installing top cowling

1. Check the rubber seal for damage. If the rubber seal is
damaged, have it replaced by a Yamaha dealer.
1. Rubber seal
2. Apron
2. Check that the rubber seal is seated all the way around
the aprons.
3. Check that all of the cowling lock levers are pulled out-
ward and turned upward.
4. Place the top cowling on the aprons.
1. Top cowling
5. Turn the cowling lock levers downward, and then push
them inward to secure the top cowling.
Operation
3 2
1
2
1
34