Yamaha F50D Servise Manual page 309

Removing the PTT unit
9 After tilting the swivel bracket up, make
sure to support it with the tilt stop lever.
Otherwise, the swivel bracket could sud-
denly lower if the PTT unit should lose
fluid pressure.
9 When removing the PTT unit with the
power unit installed, make sure to sus-
pend the outboard motor. If the out-
board motor is not suspended it can fall
suddenly and result in severe injury.
1. Fully tilt the swivel bracket up, and then
support it with the tilt stop lever 1.
1
2. Remove the lower mount shaft bolts 2,
washers 3, and then remove the lower
mount shaft 4.
3. Remove the circlip 5 and upper mount
shaft 6, and then remove the PTT unit
7 from the bracket assembly.
1
5
3
2
Installing the PTT unit
9 After tilting the swivel bracket up, make
sure to support it with the tilt stop lever.
9 When installing the PTT unit with the
power unit installed, make sure to sus-
pend the outboard motor. If the out-
board motor is not suspended it can fall
suddenly and result in severe injury.
1. Fully tilt the swivel bracket up, and then
support it with the tilt stop lever 1.
1
PTT unit
6
7
4
9-30
0
1
2
3
4
5
6
7
8
9
10
A