Digisol DG-SC2100 User Manual page 39

Channel
Basic Rate
Authentication
Encryption Type
DG-SC2100/DG-SC2100W User Manual
know its SSID and input it here, or you will not be able
to connect it.
Select the radio channel you wish to use here. When
network type is 'Infrastructure', the radio channel is
auto-selected according to the channel that wireless
access point uses. You can only select the channel
number when network type is 'Adhoc'.
You can select the wireless data transfer rate here,
from 1Mbps to 54Mbps. Maximum transfer rate for
802.11b wireless network is 11Mbps and maximum
transfer rate for 802.11g wireless network is 54Mbps.
If you have a wireless router other than 802.11g
standard, select Auto under Basic rate option.
It's recommended to select 'Auto', so the data transfer
rate will vary according to the actual signal strength
and quality.
Select the wireless authentication here. This setting
must be the same as that in the selected wireless access
point.
When you select a wireless access point from the list,
it's authentication type will be selected automatically.
The same should not be modified, else the IP Camera
will not be able to connect to the wireless access point.
Available options are: None (no authentication), Open
System, Shared Key System, WPA-PSK, WPA2-PSK
and WPA None (WPA None is only for Adhoc).
Select the wireless authentication here. This setting
must be the same as that in the selected wireless access
point.
When you select a wireless access point from the list,
it's encryption type will be selected automatically. The
same should not be modified, else the IP Camera will
not be able to connect to the wireless access point.
Available options are: None, WEP, TKIP and AES. The
options available here will vary depending on the
authentication type selected. If an authentication type
does not support encryption, this field will be grayed
out.
39