Oracle X4-2B Installation Manual page 93

Power on or restart the server, as follows:
2
To power on the server, use one of the following methods:
■
From the Oracle ILOM web interface, click Host Management > Power Control, and then
■
click Power On from the menu.
From the Oracle ILOM CLI, type:
■
-> start /System
When prompted, type y to confirm:
Are you sure you want to start /SYS (y/n)? y
Starting /System
To restart the server, use one of the following methods:
■
From the Oracle ILOM web interface, click Host Management > Power Control, and then
■
select Reset from the menu.
From the ILOM CLI, type:
■
-> reset /System
When prompted, type y to confirm:
Are you sure you want to reset /System (y/n)? y
Performing hard reset on /System
From Oracle ILOM, start the host console using one of the following methods:
3
From the Oracle ILOM web interface, click Remote Control > Launch Remote Console.
■
From the Oracle ILOM CLI, type:
■
-> start /HOST/console
When prompted, type y to confirm:
Are you sure you want to start /HOST/console (y/n)? y
Serial console started.
The server begins the host boot process. After the server boots, the GRUB menu appears (see
4
example below). Press a key other than Enter to pause, or in 5 seconds the highlighted selection
will be used.
GNU GRUB version 0.97 (612K lower / 2082932K upper memory)
+-------------------------------------------------------------------------+
Oracle Linux Server-uek (2.6.39-200.24.1.el6uek.x86_64)
Oracle Linux Server (2.6.32-279.el6.x86_64)
Oracle Linux Configuration Worksheet
93