Optional) Install Switch Module - HP ProCurve Switch 1600M Installation Manual

2. (Optional) Install Switch Module

Install a switch module into the slot as shown in the illustration below. For
installation details, see the instructions in the manual that comes with the
module.
The slot cover can be removed with either a flat-bladed or Torx T-10 screw-
driver. Retain the slot cover for future use.
N o t e s
Insert module into the guides and slide it
in until it stops. Then press in firmly until
the module "snaps" into place and is
flush with the face of the switch. Then
make sure you tighten the retaining
screws on the module .
Any of the supported switch modules can be installed in the slot.
The module can be "hot swapped", installed when the switch is powered
on and normally will be immediately operational. But, if the module is
replacing a module of a different type that was previously installed in the
slot, the switch must be rebooted after the module is installed. See "Hot
Swapping the Switch Port Module" on page 2-15.
Make sure the module is fully installed and that you screw in the
retaining screws to secure the module in place.
If you do not install a module in the slot, make sure that the slot cover
plate is still attached over the slot for safe operation and proper switch
cooling.
Installing the Switch 1600M
Installation Summary
2-5