Wall Mounting; Connect The Switch To A Power Source - HP ProCurve Switch 1600M Installation Manual

Wall Mounting

You can mount the switch on a wall as shown in the illustration below. Note
that the switch should be mounted only to a wall or wood surface that is at
least 1/2-inch plywood or its equivalent.
1. Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the switch with the included 10-mm M4 screws.
2. Attach the switch to the wall or wood surface with 5/8-inch number 12
wood screws (not included).

6. Connect the Switch to a Power Source

1. Plug the included power cord into the switch's power connector and into
a nearby AC power source.
2. Re-check the LEDs during self test. See "LED Behavior" on page 2-7.
Installing the Switch 1600M
Installation Summary
2-11