For The Hp E8200 Zl Switches Only; E8200 Zl Management Module Dependencies; Using A Spare Or E8212 Zl Management Module In An E8206 Zl Switch - HP J8726A Installation Manual

HP ProCurve Switch
8200zl Management
Module (J9092A)
HP ProCurve Switch
8200zl Fabric Module
(J9093A)
HP ProCurve Switch
8200zl System Support
Module (J9095A)

For the HP E8200 zl Switches Only

The following modules are designed specifically for the E8200 zl switches only.
Module

E8200 zl Management Module Dependencies

The HP E8206 zl and E8212 zl switches both use the same management module
(J9092A). However, the E8206 zl switch Management Module requires soft-
ware release K.14.34 or later, and the E8212 zl switch Management Module
requires software release K.12.31 or later.
Using a spare or E8212 zl Management Module in an E8206 zl
switch
Any J9092A management module will operate in both the E8206 zl and E8212
zl chassis when the correct minimum software version is loaded prior to
installing the module. If you want to install a management module taken from
an E8212 zl switch into an E8206 zl switch, you will first need to update the
module's software to its minimum supported release, K.14.34 or greater.
HP Switch zl Modules
Description
The switch requires at least one
management module to operate.
The management module
maintains persistent images of all
software that runs on the system.
The primary non-volatile storage
medium is a Compact Flash card
located on the module. Two of
these can be installed as a
redundancy feature.
The switching fabric is provided by
two fabric modules. These
modules are load sharing, and
should one fail the other one can
run the system at half the total
bandwidth.
The SSM contains all the circuitry
for monitoring the status of the
different components of the
switch.
9