Verify The Switch Operates Correctly - HP ProCurve Switch 1600M Installation Manual

Installing the Switch 1600M
Installation Summary

4. Verify the Switch Operates Correctly

After you have installed a switch port module, but before mounting the switch
in its network location, you should first verify that it is working properly by
plugging it into a power source and verifying that it passes its self test.
1.
N o t e
The Switch 1600M does not have a power switch. It is powered on when the
power cord is connected to the switch and to a power source.
If your installation requires a different power cord than the one supplied with
the switch, be sure to use a power cord displaying the mark of the safety
agency that defines the regulations for power cords in your country. The mark
is your assurance that the power cord can be used safely with the switch.
2.
2-6
Connect the power cord supplied with the switch to the power connector
on the back of the switch, and then into a properly grounded electrical
outlet.
Connect power cord to
the power connector
Check the LEDs on the switch and on the switch module (if installed). The
LED behavior is described on the next page.