Pw Sensor - Epson Stylus Office T1110 Service Manual

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
4. While pressing the guide pin on the PF Encoder Sensor Holder using tweezers,
slide the holder upwards to release the three tabs, and remove the PF Encoder
Sensor Holder.
Guide pin
Figure 4-158. Removing the PF Encoder Sensor Holder
Make sure that the PF Scale is in the slit on the PF Encoder Sensor.
PF Scale
Figure 4-159. Reinstalling the PF Encoder Sensor Holder
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
Tabs
Slit
PF Encoder Sensor

4.6.3 PW Sensor

1. Remove the Carriage Shaft / Carriage Unit. (p.88)
2. Remove the C.P.B. (P1) M1.7 x 5 screw that secures the PW Sensor Holder, and
remove the PW Sensor Holder from the Carriage Unit.
Carriage Unit Bottom Side
Figure 4-160. Removing the PW Sensor Holder
3. Disconnect the PW Sensor FFC from the PW Sensor connector, and remove the
PW Sensor.
PW Sensor FFC
打印机驱动下载 http://www.printerwhy.com/
Removing the Sensors
PW Sensor Holder
Connector
Figure 4-161. Removing the PW Sensor
Revision A
12) C.P.B. (P1) M1.7x5
(0.8±0.2 kgf.cm)
PW Sensor
125
Confidential