Epson Stylus Office T1110 Service Manual page 60

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
Observed Faults Details of the Fault
Borderless Printing Cannot make a borderless
printing (The printer prints with
margins despite the borderless
setting).
Pattern misalignment The vertical lines are not aligned
for vertical lines and at monochrome draft printing.
such
Occurrence Timing Details of the Fault
– Printing operation is performed
normally but abnormal noise is
produced at power-on or during
operations.
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Troubleshooting
高速行式打印机 http://www.lineprinter.com.cn/
Table 3-12. Print Quality Troubles
Faulty Part/
Part Name
PW sensor 1. Check if the paper dust or scrap of the paper is attached to the
Front Paper Guide.
2. Check that PW adjustment has executed properly.
Adjustment 1. Check that BAND printing adjustment has executed properly.
Table 3-13. Abnormal Noise
Faulty Part/
Part Name
Adjustment 1. Check that PF Belt Tension Adjustment has been executed
properly.
Carriage Shaft 1. Check that the Carriage Shaft is fully lubricated with grease.
Overview
Check Point
Check Point
打印机驱动下载 http://www.printerwhy.com/
Revision A
Remedy
1. Remove the paper dust or scrap of the paper.
2. If the borderless printing still can not be made
after the adjustment, replace the PW Sensor
with a new one.
Refer to Chapter 5 "Adjustment".
3. Make the adjustment according to the specified
adjustment priority.
Refer to Chapter 5 "Adjustment".
Remedy
1. Make the adjustment according to the specified
adjustment priority.
Refer to Chapter 5 "Adjustment".
1. Wipe the grease applied to the Carriage Shaft
with a dry, soft cloth, and then apply grease (G-
71).
Refer to Chapter 6 "Maintenance".
Confidential
60