Front Decoration Plate Left/Right; Rear Housing - Epson Stylus Office T1110 Service Manual

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100

4.2.3 Front Decoration Plate Left/Right

1. Open the Stacker Assy.
2. While releasing the hook on the Front Decoration Plate Left, open the plate in the
direction of the arrow, and remove it.
3. In the same way, remove the Front Decoration Plate Right.
Figure 4-6. Removing the Front Decoration Plate Left/Right
When installing the Front Decoration Plate L/R, insert the two
hooks at the bottom of them into the holes of the Lower housing,
then secure the Front Decoration Plate L/R with the other hooks.
Hook
Figure 4-7. Reinstalling the Front Decoration Plate Left/Right
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
Hook
Front Decoration Plate Left
Removing the Housings

4.2.4 Rear Housing

1. Remove the two C.B.P. M3 x 8 screws and the C.B.S. M3 x 6 screw that secure the
Rear Housing.
2. Disengage the two tabs from the Upper Housing and remove the Rear Housing.
Tab
2
Figure 4-8. Removing the Rear Housing
Tighten the screws in the order shown in
打印机驱动下载 http://www.printerwhy.com/
Revision A
4) C.B.P. M3x8
(6±1 kgf.cm)
2) C.B.S. M3x6
(6±1 kgf.cm)
1
Rear Housing
Figure 4-8.
Confidential
Tab
68