Epson Stylus Office T1110 Service Manual page 77

_______________________________________________________________________________________
WorkForce 1100/Epson Stylus Office T1110/B1100/T1100/Epson ME Office 1100
REMOVING THE POWER BOARD
1. Remove the Board Assy (Main Board/Power Supply Board). (p.75)
When disconnecting the Power Board cable, be sure to unlock
C A U T I O N
CN60 on the Main Board.
Lock
Figure 4-26. Handling the Power Board cable (CN60)
2. Disconnect the Power Board cable from connector CN60 on the Main Board. (p.76)
3. Remove the four C.B.S. M3 x 6 screws that secure the Power Board and remove
the Power Board from the Board Assy.
3
Power Board
1
Figure 4-27. Removing the Power Board
Tighten the screws in the order shown in
4-27.
_______________________________________________________________________________________
打印机维修论坛 http://www.printerwhy.net/
Disassembly And Assembly
高速行式打印机 http://www.lineprinter.com.cn/
Unlock
2
4
2) C.B.S. M3x6
(6±1 kgf.cm)
Figure 4-25 and Figure
Removing the Boards
After replacing or removing the Main Board and the Power Board,
A D J U S T M E N T
R E Q U I R E D
always make the required adjustments referring to the following.
• "Chapter 5
Adjustment
打印机驱动下载 http://www.printerwhy.com/
Revision A
(p.128)"
77
Confidential